30/40
1. To replace the lamp, loosen the screws on the rear of the appliance (see Fig. 3, No. 1)
and remove the opening as shown in Figure 3, No. 2.
2. Now remove the defective lamp from the socket by turning anticlockwise (see Fig. 3,
No. 3) and replace it with a new clear glass lamp of the type 25W E14 (candle form).
Then screw the cover back on.
Make sure you do not turn the lamp too much when screwing in the lamp. Pay attention to
the notes on the lamp.
3.5 Storage
Protect the appliance against dust, dirt and insects. Cover the appliance so that it is
protected from impurities and damage or malfunctions caused by this.
3.6
Repacking for private transport purposes
Always pack the appliance in its original packaging for transportation to prevent
transport damage.
4.
Cleaning and Maintenance
4.1 Safety measures
P
Always pull the mains plug out of the socket before servicing the appliance.
P
Only begin the maintenance or repair work once the appliance has completely cooled
down.
4.2 Cleaning
The appliance should be covered after each use to prevent contamination by impurities.
Do not cover the appliance until it has fully cooled down.
If the appliance has nevertheless become dirty, observe the following notes during cleaning:
P
Always clean the appliance while cool.
P
Pull out mains plug before any work.
P
Only clean the appliance with a dry, soft cloth. Never use sharp and/or abrasive
cleaning agents.
FIN_DE GB RO BA 10303146 Elektro Kamin 1500 W Mini.indd 30
03.06.2014 15:07:27
