Please read carefully and keep in a safe place.
1- WARNINGS
It is essential that you read these instructions carefully and comply with the following recommendations.
• This appliance complies with European directives 73/23/EEC and 89/336/EEC.
• Before using, always check the condition of the appliance, the power socket and the power lead.
• Do not pull on the power cable or the appliance, even to unplug it from the wall socket.
• Fully unwind the lead each time before use.
• Never insert objects into the appliance (e.g. needles...).
• When in use, this appliance must be kept out of the reach of young children, animals and certain handicapped people.
• Do not use your appliance in a dusty room or a room where there is a risk of fire.
• This appliance is intended for domestic use only. It must therefore not be used in industrial applications.
• The warranty will be void in the event of damage arising from improper use.
• If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a person with similar qualifications to avoid any danger.
• Do not place the unit directly beneath an electrical outlet.
• If the unit is attached to a wall, the outlet must remain accessible.
• Disposal of product no longer suitable for use: Place the unit in specialised collection/refuse treatment centres.
2- VERY IMPORTANT
• WARNING: To avoid risk of overheating, NEVER PLACE OBJECTS ON TOP OF THE UNIT.
• Do not use the unit in the proximity of flammable objects or products (curtains, aerosols, solvents, etc.)
• Never use the unit in an inclined or horizontal position.
• Do not use this appliance near a bath, shower, sink or swimming pool.
• NEVER ALLOW WATER TO PENETRATE THE APPLIANCE.
• Do not touch the appliance with wet hands.
• In the event of a long absence: turn the button A (fig.4b/4c) to the initial setting (SO6020/SO6030) and unplug the appliance
or turn the button B (fig.4a) to the initial setting (SO6010) and unplug the appliance.
4- VOLTAGE
• Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted
to the power level indicated.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance (dual electrical insulation ).
5- SAFETY
SO6010/SO6020:
• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once ithas cooled. If the fault persists
or gets worse, a thermal fuse shuts the appliance down definitively and it must then be taken to an approved service centre.
SO6030:
• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once ithas cooled. If the fault persists
or gets worse, a thermal fuse shuts the appliance down definitively and it must then be taken to an approved service centre.
• If the unit tips over, a safety device automatically turns it off. When placed back in an upright position, it will once again begin to operate.
In both cases, a warning beep will occur and the "Signal Protect" indicator (D) will light up.
6- OPERATION
Before turning the unit on, make sure:
- it is positioned as described in these instructions,
- that it is placed in a flat and horizontal position, and;
- that the air intake and outlet screens are free of all obstacles.
• Function Selection (SO6020/SO6030):
Select the desired function by turning switch (A) to line up the marking on the switch with one of the following symbols:
: on
: Cooling
• : 1100W
• • : 2200W
• Indicator:
- On/Off indicator (C fig.4a/4b/4c), lights up when the unit is turned on.
"Signal Protect" indicator (D fig.4c), lights up in case of overheating or if the unit tips over. Only for Mod.SO6030.
• Thermostat:
Adjust the temperature setting, according to your own comfort, by turning button B (fig.4a/4b/4c).
• Frost-free setting :
This setting enables you to automatically maintain the temperature above 0°C in a normally insulated room, whose volume corresponds to the power of your
appliance.
SO6010 : To do this, plug in your appliance and turn button B (fig.4a) so that the marker is opposite the “ ”.
SO6020/SO6030 : Plug in the unit and turn switch B to line up the marking on the switch with the “ ” and turn switch A to select one of the
following: • 1100W or •• 2200W
• Cold ventilation setting : (SO6020/SO6030)
This setting enables you to use your fan heater as a fan in summer.
3- USE IN THE BATHROOM (protection against splashing with water)
• This “ IP21 “ unit has been specially designed so that it can be used in any room in your house, including those where there is a risk
of water being splashed onto it from above (kitchen, bathroom, etc.).
• However, the electrical installation in the room, the installation of the unit and the way the unit is used must all comply with the
safety standards in force in your country.
GB
MAX
MIN
NOT 040077 balnéa Rowenta 2/09/04 9:31 Page 3
