Turn off ARTEC temporarily.
(model with remote control)
• Press the PAUSE button; the infrared
pickup light stays on, the setting is
memorised, and the appliance
remains powered ON.
Attention! To turn the appliance off
for a long time, always press the
(
) pedal. If the supply current is
interrupted and then restored
(power failure, unplugging and
plugging in again) ARTEC restarts
automatically.
Turn off ARTEC
• After use, press the
pedal and
unplug the vacuum cleaner.
TO MAINTAIN AND CLEAN ARTEC
Important ! Always turn off and
unplug ARTEC before maintenance
or cleaning.
Change the dustbag.
• The bag full indicator (according to
model) informs you that the bag is full
or blocked with dust particles. If the
indicator remains lit replace the bag
or remove the textile fibres (with the
nozzle or Delta Head lifted off the
ground and the power set at its max
level).
• Lay the appliance flat and remove
the suction hose: press and pull.
Open the cover
• Press on the bag support to unfasten
it, gently remove the bag and throw
it in a waste bin.
If using a Wonderbag: press on each
side of the ring to release the bag
and dispose of bag in a waste bin
Note: do not throw away the
yellow support, as this will be used
for fitting a new Wonderbag.
• Push down the cardboard part of the
new bag, with the arrows pointing
towards the bottom of the bag
support. Push the bag support until
it clicks into place.
• Close the cover again and press until
it clicks.
Empty the cloth dustbag
(according to model).
• Remove the cloth dustbag, hold it
over a dustbin and remove the bar
which holds it closed. Empty and
brush the dustbag, then close it
again.
• Put back in place and close the cover
again.
Note: The lid will not close unless
you have fitted a new bag.
Important !
Check, clean and replace the
various filters regularly.
Clean the foam air-intake filter.
Note:
The protective foam should always
be in place during use.
• Open the cover and remove the
dustbag.
• Remove the foam and clean it after
every five bag changes, using luke-
warm soapy water (mild washing-up
liquid). Rinse, dry and replace the
foam.
Cleaning the air-outlet foam filter.
• Take out the filter cartridge, remove
the foam filter and clean it after every
five bag changes, using lukewarm
soapy water (mild washing-up liquid).
Rinse, dry and replace the foam.
Change the micro-active filter
(ref. Kit ZR 455) (according to
model).
• Change it once for every five
changes of the dustbag. It is located
in the filter cassette.
PRESS
