WiFly GSX
WiFlyGSX-um.pdf 11/11/2009
www.rovingnetworks.com
Phone 408-395-6539
-
12 -
set sys iofunc <value>
sets the IO port alternate functions. Bit-mapped value. For more
details see section 10.5
set sys mask <mask>
sets the IO port direction mask. Bit-mapped value. For more
information see section 10.5
set sys printlvl <value>
sets numerous print functions. 0 = quiet 1 = connect information
Default is 1.
set sys output <value> <mask>
sets output PIO pins to HIGH or LOW. Bit-mapped value.
Optional mask only sets a subset of pins.
set sys sleep <secs>
sets the sleep timer. 0 disables.
NOTE: If not using Sensor pins to wake the module, be sure to set
the wake timer before issuing the sleep timer or the module will not
wake up.
See section 10.1 for more details on using system timers
set sys trigger <value>
sets the sensor input(s) to wake on (0-3). Bit-mapped value. 0
disables.
set sys wake <secs>
sets the auto wake timer. 0 disables. See section 10.1 for more
details on using system timers
5.9
TIME Server Parameters
set time address <addr>
sets the time server address. (sNTP servers)
set time port <num>
sets the time server port number. Defaults to 123 which is almost
always the sNTP server port.
set time enable <value>
Enable or disable fetching time from the specified sNTP time server.
Default=0= disabled. A value or 1 gets time only once on power up.
Any value > 1 gets time continuously every <value> minutes.
5.10
UART Parameters
set uart baud <rate>
set the UART baud rate. Valid settings are {2400, 4800, 9600,
19200, 38400, 57600, 115200, 230400, 460800, 921600}.
Example : “set u b 9600” sets the baud rate to 9600 baud.
NOTE: the RS232 interface on the RN-134 does not work above
230400
set uart instant <rate>
This immediately changes the baudrate. This is useful when testing
baudrate settings, or switching baudrate “on the fly” remotely while
connected over TCP. This setting does not affect configuration.
