WiFly GSX
www.rovingnetworks.com
WiFlyGSX-um 9/16/2010
809 University Avenue
•
Los Gatos, CA 95032
•
Tel (408) 395-6539
•
~ 19 ~
1)
more chars come in, in which case it will get flushed, or
2)
no chars come in and a new connection is made, then the chars will get forwarded.
If this setting is enabled (set uart mode 0x10), any unsent RX data is still in the buffer is flushed when a
connection is closed.
set uart tx <0, 1>
Disables or enables the TX pin= PIO10 of the UART. Disable will set
PIO10 to an INPUT with weak pulldown.
NOTE: Due to an issue in the UART hardware, the UART does not support even or odd parity.
5.11.
WLAN Parameters
set wlan auth <value>
Sets the authentication mode. Not needed unless using auto join mode 2.
i.e.
set wlan join 2
Note: During association the WiFly module interrogates the Access Point
and automatically selects the authentication mode.
The current release of Wifly firmware supports these security modes:
• WEP-128 (open mode only, NOT shared mode)
• WPA2-PSK (AES only)
• WPA1-PSK (TKIP only)
• WPA-PSK mixed mode (some APs, not all are supported)
Value
Authentication Mode
0
Open (Default)
1
WEP-128
2
WPA1
3
Mixed WPA1 & WPA2-PSK
4
WPA2-PSK
5
Not Used
6
Adhoc, Join any Adhoc network
set wlan channel <value>
sets the wlan channel, 1-13 is the valid range for a fixed channel. If 0 is
set, then scan is performed, using the ssid, for all the channels set in the
channel mask.
set wlan ext_antenna <0, 1>
determines which antenna is active, use 0 for chip antenna, 1 for UF.L
connector. Default = 0. Only one antenna is active at a time and the
module must be power cycled after switching the antenna.
