Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
1-800-658-5925
Page 3 of 3
12.) Install the two remaining partitions #17D above all the intermediate floors in the same manner
used for installing the lower partition.
13.) Install one door assembly (which includes two doors) to the front left side of the enclosure
with the clips attached along the edge of the panel. Be sure to position the door so that the
handles are on the right side of the panel.
14.) Connect the second door assembly to the first one just installed, with the clips attached along
the right edge of the first.
15.) Connect the third door assembly to the right hand side of the enclosure with the clips that are
already attached to the door assembly frame.
16.) Close all three door panels against the front of the enclosure and connect the second and
third panels together with the clips attached along the right edge of the second panel.
17.) Connect the interior partitions installed earlier to the frame pipes of the front door panels with
#250 clips; use two clips along the front of each partition. See
Photo 8
above for clarification.
18.) Connect the floor panels to the front door panels with two #250 clips under each door as
shown in
Photo 9
above.
19.) Place the top panel (lid) #C72C with attached clips onto the top of the cat cage and fasten
clips down onto tops of panels.
20.) Congratulations on completing the assembly of your new Roverpet
Kali’s Villa-4
#K969F
…
enjoy
Property of Roverpet