Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
1-800-658-5925
Page 2 of 3
2.) Stand 3-panel assembly up on floor; orient assembly with clips attached along its edge to the
left as shown in
Photo 1
below.
Photo 1
Photo 2
Photo 3
3.) Unfold panel assembly and position it to form a 90°angle as shown in
Photo 2
above.
4.) Stand 2-panel assembly up on the floor, also in the form of a 90°, and orient it so the panel
without clips attached to its edge is positioned next to clips attached to 3-panel assembly.
See
photo 3
above.
Photo 4
Photo 5
Photo 6
5.) Clip the two panel assemblies together and position the 3 clips equidistant from each other
along the length of the panel frames. The connected panels should now be resting in a C-
shape as shown in
Photo 4
above.
6.) Place the floor, pipe side up, into the bottom of the enclosure.
7.) Connect the floor to the side panels with one #250 clip installed at the center of each panel
around the perimeter. See the
Photo 5
on the previous page.
8.) Install (16) #FDC clips onto the crossbar of the standing panels (two per panel, between the
1
st
and 2
nd
bars from the edges). #FDC clips are engaged from the bottom of the crossbar
and then rotated down into position as shown in
Photo 6
on the previous page.
Photo 7
Photo 8 Photo 9
9.) Install two partitions #17D into the bottom of the enclosure by connecting them to one of the
rear panel frame pipes with two #250 clips each as shown in
Photo 7
above.
10.) Install the intermediate floor into the enclosure and onto the previously installed #FDC clips
along the panel crossbars.
11.) Connect the floor to the side panels with one #250 clip installed at the center of each panel
around the perimeter as was done with the bottom ground panel.
Orient 3-panel
assembly so
that the clips
attached
along its edge
are on the left
as shown
here.
Attach a #250
clip at the
center of each
panel as
shown here.
Connect
the
partitions
to the
door
panels
with #250
clips as
shown
here.
Connect
the
partitions
to the
rear
panels
with #250
clips as
shown
here.
Connect
the floor
panels to
the door
panels with
two #250
clips under
each door
as shown
here.