Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
1-800-658-5925
Page 3 of 3
10.) Install the intermediate floor into the enclosure and onto the previously installed #FDC clips
along the panel crossbars.
11.) Connect the floor to the side panels with one #250 clip installed at the center of each panel
around the perimeter as was done with the bottom ground panel.
12.) Install two more partitions #14D above all the intermediate floors in the same manner used
for installing the lower partition.
13.) Install one door assembly (which includes two doors) to the front left side of the enclosure
with the clips attached along the edge of the panel. Be sure to position the door so that the
handles are on the right side of the panel.
14.) Connect the second door assembly to the first one just installed, with the clips attached along
the right edge of the first.
15.) Connect the third door assembly to the right hand side of the enclosure with the clips that are
already attached to the door assembly frame.
16.) Close all three door panels against the front of the enclosure and connect the second and
third panels together with the clips attached along the right edge of the second panel.
17.) Connect the interior partitions installed earlier to the frame pipes of the front door panels with
#250 clips; use two clips along the front of each partition. See
Photo 8
above for clarification.
18.) Connect the floor panels to the front door panels with two #250 clips under each door as
shown in
Photo 9
above.
19.) Place the top panel (lid) #C72C with attached clips onto the top of the enclosure and fasten
clips down onto tops of panels.
20.) Congratulations on completing the assembly of your new Roverpet Paws & Claws Resort
#K889F…
enjoy
Property of Roverpet