Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
(800) 658-5925
Page 1 of 3 for Gate Assembly
Roverpet Dog Gate Assembly Instructions
Inventory List: Roverpet #36RP & 48RP Pet Gate
The inventory for Roverpet Dog Gate includes;
(2)
Roverpet PVC Panels
(1) #
RGC Clasp Set & mounting hardware
(1)
#RGH Gate Handle
(6)
#250 Clips
Assembly Procedure
1.) Unpack contents of shipping carton and compare to inventory list above.
2.) Decide which mounting option will best fit your needs. See bullets below for mounting options.
Face mounted gates require the
hinging and latching sides
of the gate to be mounted to the trim-side of a
doorway/hallway, and
less than 42” wide
.
Example: mounted at the end of a hallway where the ends of the walls are accessible.
‘V’ Shape mounted gates require the
hinging and latching sides
to be opposing to one another, and
less than 42”
wide
. Most mounting positions can accommodate
‘V’ Shaped mounting.
Example: mounted in the middle of a hallway with no doorways on either side.
If you are mounting the gate with additional
Stacking Panels
in a face mounted configuration, the overlapping upright
bars need to be in-line with one another for proper setup. (See Figure 1) Read both sets of instructions completely
before beginning the installation.
If your mounting location requires you to have a gate width
wider than 42”
, an extension panel will need to be
purchased from
www.roverpet.com
.
For maximum strength capabilities, mount the Roverpet Dog Gate on the same side of doorway/hallway that your pet will be
contained. Allow a
‘V’ Shaped arrangement to extend into the area that your pet will be contained.
***Continue assembly instructions on next pages for the mounting configuration desired***
Assembly for Doorway/Hallway Face Mounting
(See Figure 1)
Figure 1
Figure 2
#RGH Handle
#250 Clips
#350 Clasps
#450 Clasps
