Rover XT133, Operator'S Manual, Page: 11 / 22

- 11 -
STARTING COLD ENGINE
WARNING
: Before starting the
engine, keep the cutting attachment
clear of everything around it.
1. Use the mixing tank to mix the fuel and oil.
Fill fuel tank with the mixture. See “Fuel and
Oil Instructions”.
2. Press and hold the throttle trigger and
throttle lockout at the same time, meanwhile
use the other hand to push the ignition
switch to the “START” position.
3. Release throttle lockout, throttle trigger and
ignition switch one by one.
4. Fully press and release the primmer bulb for
10 times. Some amount of fuel should be
visible in the primer bulb and fuel lines.
5. Move choke lever to the “CLOSE” position.
6. Hold the unit with your left hand and press
it against the ground.
8. Repeat several times until the engine starts.
Note : Unit is properly warmed up when engine
accelerates without hesitation.
9. Move choke lever to “HALF OPEN” position.
Allow the engine to run for 1-2 minutes to
™ƒ”—’ƒ ‘”†‹‰–‘–Š‡†‹ơ‡”‡–
temperatures.
Once the engine is warmed up, place the choke
lever to the “Full Open” position. Press throttle
trigger to release throttle lock out. The ignition
switch will automatically switch to normal
running position, and the engine will run at
idling speed.
7. While holding the starter handle in right
hand. Gently pull the starter rope out until
you feel that the pawls hook onto the
ƪ›™Š‡‡Žǡƒ†–Š‡’—ŽŽ–Š‡•–ƒ”–‡”“—‹ Ž›Ǥ
Fully press and release the primmer bulb fo
h i i d l h h k
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS