MAINTENANCE
24
F 050759L
ØÑÉ ÌÑ ÝØÛÝÕ ßÒÜ ßÜÖËÍÌ ÌØÛ ÜÎ×ÊÛ ÞÎßÕÛ
Completely push the clutch/brake pedal forward. Set the parking
brake. Move the shift lever to the neutral (N) position. Push the unit.
If the rear wheels rotate, adjust or replace the brake pads. Adjust the
drive brake
as follows.
1. The location of the
drive brake
is on the right side of the
gearbox
(Figure 16).
2. Make sure the parking brake is set and the shift lever is in
neutral (N). Turn the
hex nut
in a clockwise direction until the
rear wheels do not turn when the unit is pushed forward.
3. Release the parking brake and push the unit. If the unit does not
roll, turn the
hex nut
in a counterclockwise direction until the
unit rolls.
4. Set the parking brake. Push the unit. If the rear wheels do not
turn, the
drive brake
is correctly adjusted. Release the parking
brake.
WARNING: If you cannot correctly adjust the drive
brake, replace the brake pads. Correct replacement
parts and assistance are available from an autho-
rized service center.
Figure 16
Drive Brake
Gearbox
Hex Nut
HOW TO CHECK AND ADJUST THE CLUTCH
If the motion drive belt is loose, the clutch will slip when; (1) going
up a hill, (2) pulling a heavy load, or (3) the unit will not move forward.
Adjust the clutch as follows.
WARNING: Before you make an inspection, adjust-
ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the wire from the spark plug to
prevent the engine from starting by accident.
1. Check the routing of the motion drive belt. Make sure the belt
is installed correctly and is inside all the belt guides.
2. Remove the
cotter pin
,
washer
, and
brake spring
from the
adjustable nut
(Figure 17).
3. Disconnect the
adjustable nut
from the
brake lever assembly
and the
parking brake latch.
4. Align the hole in the
brake lever
with the hole in the
frame
. Hold
the
brake lever
in place with a 1/4 inch (6 mm) pin or bolt
(Figure 17).
5. Pull the clutch rod forward until tight. Turn the
adjustable nut
until the nut will fit through the hole in the
brake lever
.
6. Assemble the
adjustable nut
to the
parking brake latch,
brake lever
and
brake spring
. Fasten with the
washer
and
cotter pin
.
7. Remove the 1/4 inch (6 mm) pin or bolt.
8. If the belt still slips after the clutch has been adjusted, then the
motion drive belt is worn or damaged and must be replaced.
See
How To Replace The Motion Drive Belt
.
Clutch Rod
Brake Lever
Assembly
ß¼¶«-¬¿¾´» Ò«¬
Figure 17
Cotter Pin
Þ®¿µ» Í°®·²¹
Washer
Parking Brake
Latch
Pin or Bolt
Summary of Contents for Clipper 405012x108A
Page 1: ...F 050759L Owner s Manual model 405012x108A...
Page 35: ...NOTES 35 F 050759L...
Page 50: ...50 F 050759L...
Page 52: ...52 F 040736L...
