Rover 75 Saloon, Owner'S Handbook Manual

Page: 157 / 285

Symphony - Radio Tuning
157
3
Symphony - Radio Tuning RADIO TUNING
Manual tuning
If you know the frequency of the radio station you are seeking, or
you need to select a radio station that is too weak to be found by
automatic tuning, use manual tuning, as follows:
Select the desired waveband (FM or AM), then press the manual
tuning selector (6) (the ‘MAN’ indicator illuminates in the
display). By pressing either tuning button (5), the frequency
changes (either up or down) in steps of 0.1 MHz for FM, or 9 kHz
for MW, or 1 kHz for LW.
Fast manual tuning
By keeping either tuning button depressed, the waveband is
scanned rapidly (up or down) until the button is released.
Automatic tuning
Select the required waveband (FM or AM), then briefly press one
of the tuning buttons (5) - (‘SEEK’ and chevrons indicating the
direction of search appear in the display).
The radio automatically searches the frequency range (either up or
down depending upon which of the tuning buttons is pressed)
looking for a radio station of acceptable strength. Once a suitable
station is found, the search stops unless you choose to continue by
pressing the tuning button again.
NOTE: If you have a car telephone with a mute signal output connected
to the radio, the radio automatically mutes when the telephone is in use.
Waveband scan
Select the desired waveband (FM or AM) and press the SCAN
button (8). The radio scans through the waveband, seeking stations
of acceptable strength. Each time a strong signal is found, the radio
plays that station for 5 seconds (the display shows waveband and
frequency, accompanied by the word ‘SCAN’). After 5 seconds
the radio mutes and scans for the next station, and so on.
To stop the scan, press the button again - the radio commences
playing the station at which the scan was stopped.
MONO/STEREO
Whenever the FM waveband is selected, the radio automatically
reproduces stereo sound, provided a suitable signal is available.
However, if a signal becomes too weak for good stereo reception,
only mono sound is produced until the signal strengthens
sufficiently for stereo sound reproduction.
ICE0155
8 5 6 5