9
VERTICAL CONTACT TOASTER
P/N 1011233 Rev. B 09/13
LIGHTER
PROGRAM
DARKER
Figure 5. VCT-2010 Toaster Control Panel
User Mode
User Mode allows an operator to view the toaster set-
tings but does not permit any adjustments.
1. Press and hold the
PROGRAM
button for 5 seconds.
After 5 seconds, the display will show the actual
temperature of the Platen Heater.
2. Press the
LIGHTER
button to view the setpoint of
the Platen Heater.
3. Press the
PROGRAM
button to proceed to the
Auxiliary Heater menu. The display will show the
actual temperature of Auxiliary Heater.
4. Press the
LIGHTER
button to view the setpoint of
the Auxiliary Heater.
5. Press the
PROGRAM
button to proceed to the
Motor Menu. The display will show the actual
speed of the Motor.
6. Press the
LIGHTER
button
to view the setpoint of
the Motor.
NOTE: The unit will exit User Mode after 5 seconds
of keypad inactivity.
Manager Mode
Manager Mode allows an operator to view and adjust
the following settings:
• Platen Heater Temperature
• Auxiliary Heater Temperature
• Motor Speed
• Temperature Units
Manager Mode also allows an operator to view (but
not adjust) the Ambient Temperature of the Control
Compartment.
1. Turn the unit off.
2. Turn the power on while holding the
PROGRAM
button. Continue to hold the button until “ENA”
appears on the display (after approximately 10
seconds).
3. Release the
PROGRAM
button. The display now
shows the Platen Setpoint Temperature.
4. To adjust the Platen Setpoint, press the
LIGHTER
or
DARKER
buttons to reach the desired tem-
perature.
NOTE: The recommended temperature setting for
the Platen Heater is 570°F (299°C).
OPERATION (continued)
5. Press the
PROGRAM
button to proceed to the
Auxiliary Heater Setpoint Temperature.
6. To adjust the Auxiliary Heater Setpoint, press
the
LIGHTER
or
DARKER
buttons to reach the
desired temperature.
NOTE: The recommended temperature setting for
the Auxiliary Heaters is 330°F (166°C).
7. Press the
PROGRAM
button to proceed to the
Motor Speed Setpoint.
8. Adjust the Motor Speed Setpoint by pressing
the
LIGHTER
or
DARKER
buttons to reach the
desired speed.
NOTE: The Motor Speed is adjustable from 1-100.
The recommended setting is 52.
9. Press the
PROGRAM
button
to proceed to
Temperature Units.
10. To change the Temperature Units from Fahrenheit or
Celsius, press the
LIGHTER
or
DARKER
buttons.
11. Press the
PROGRAM
button to proceed to the
Ambient Temperature of the Control Compartment.
NOTE: No changes can be made to the Ambient
Temperature of the Control Compartment.
Temperatures under 150°F (66°C) are acceptable.
12. Press and hold the
PROGRAM
button to save
any changes.
NOTE: The unit will exit Manager Mode after 30
seconds of keypad inactivity.
