3
P/N 1011283 Rev. A 03/15
IMPORTANT SAFETY
INFORMATION
Use the following guidelines for safe op-
eration of the unit.
y
Read all instructions be-
fore using equipment.
y
For your safety, the equipment is
furnished with a properly grounded
cord connector. Do not attempt to
defeat the grounded connector.
y
Install or locate the equipment only
for its intended use as described in
this manual. Do not use corrosive
chemicals in this equipment.
y
Do not operate this equipment if
it has a damaged cord or plug, if
it is not working properly, or if it
has been damaged or dropped.
y
This equipment should be serviced
by qualified personnel only. Contact
your nearest Authorized Service
Agency for adjustment or repair.
y
Do not block or cover any
openings on the unit.
y
Do not immerse cord
or plug in water.
y
Keep cord away from
heated surfaces.
y
Do not allow cord to hang over
edge of table or counter.
y
Turn the power off, unplug the
power cord, and allow unit to
cool down before performing any
service or maintenance on the unit.
NOTE:
Turning off the power switch
does NOT turn off all power to
the unit.
y
The procedures in this manual may
include the use of chemical prod-
ucts. These chemical products will
be highlighted with bold face letters
followed by the abbreviated HCS
(Hazard Communication Standard).
See Hazard Communication Stan-
dard manual for the appropriated
Material Safety Data Sheets (MSDS).
y
The equipment should be grounded
according to local electrical codes to
prevent the possibility of electri-
cal shock. It requires a grounded
receptacle with separate electrical
lines, protected by fuses or circuit
breaker of the proper rating.
y
All electrical connections must
be in accordance with lo-
cal electrical codes and any
other applicable codes.
y
Do not clean this appli-
ance with a water jet.
WARNINGS
Be advised of the following warnings
when operating and performing mainte-
nance on this unit.
y
If the supply cord is damaged, it
must be replaced by the manu-
facturer or its service agent or
a similarly qualified person
in order to avoid a hazard.
y
Do not modify the power sup-
ply cord plug. If it does not fit
the outlet, have a proper outlet
installed by a qualified electrician.
y
Do not use an extension
cord with this appliance.
y
Electrical ground is re-
quired on this appliance.
y
Check with a qualified electrician if
you are in doubt as to whether the
appliance is properly grounded.
y
When using a chemical cleaner,
be sure it is safe to use on cast
aluminum. Observe all precautions
and warnings on product label.
y
Inspection, testing, and repair
of electrical equipment should
only be performed by quali-
fied service personnel.
y
Do not use a sanitizing solution or
abrasive materials. These may cause
damage to the stainless steel finish.
y
Chlorides or phosphates in clean-
ing agents (e.g. bleach, sanitizers,
degreasers or detergents) could
cause permanent damage to
stainless steel equipment. The
damage is usually in the form of
discoloration, dulling of metal
surface finish, pits, voids, holes, or
cracks. This damage is permanent
and not covered by warranty.
y
The following tips will help
in the maintenance of stain-
less steel equipment:
• Always use soft, damp cloth for
cleaning, rinse with clear water
and wipe dry. When required,
always rub in direction of metal
polish lines.
• Routine cleaning should be
done daily with soap, ammonia
detergent, and water.
• Stains and spots should be
sponged using a vinegar solu-
tion.
• Finger marks and smears should
be rubbed off using soap and
water.
• Hard water spots should be re-
moved using a vinegar solution.
