HOT DOG CORRAL
7
P/N 1010609 Rev. E
A.J. Antunes & Co.
1
2120121
Spacer
2
2
3080158
Screw, Pan Hd., #8-32 x 5/8"
2
3
3250104
Washer, Flat, SS, 1/4"
2
4
3250169
Shoulder Bolt, Socket Hd.,
5/16 x 1/2"
4
5
3250135
Jamnut, 1/4-20
4
(early style units only)
6
1150104
Allen Wrench (not shown)
1
Item
Part
Description
Qty.
No.
Food Shield (Optional)
NOTE: Early style corrals do not have weldnuts on
inside of side covers. When installing the food shield,
jamnuts (5, figure 2) must be used.
1. Turn the rocker (power on/off) switch to the OFF
position and unplug the unit.
2. Assemble the hardware to the left and right cover
panels as shown in Figure 2.
3. If a non-pivoting food shield is desired, follow
Installation A. If a pivoting food shield is desired,
use Installation B.
Figure 2. Optional Food Shield Components
Early style units do not
have a weldnut on the
inside of the panel and
must use a 1/4-20 hex
jamnut (P/N 325P125).
On early style panels
without weldnuts, it is
necessary to enlarge the
mounting holes to accept
the 1/4-20 shoulder bolts.
4
4
3
3
1
5
Install shoulder
bolts through all
mounting holes in
food shield.
NOTE: SG-21 & SG-35 shown. SGH-20 uses same mount-
ing, but is shaped differently.
Rear Pivot - Install
rear shoulder bolts
through mounting
holes in food shield.
Front of shield rests
on top of shoulder
bolts.
Front Pivot - Install
front shoulder bolts
through mounting
holes in food shield.
Rear of shield rests
on top of shoulder
bolts.
2
Installation B–Pivoting
Installation A–Non-pivoting
