GPS/Cam Evaluation Board
Quick Start Guide
Page 2 of 7
Version 1.1
Round Solutions GmbH & Co KG
Tel +49 6103 960510 Fax +49 6103 960509
[email protected] wwww.roundsolutions.com
1 General
This evaluation board can be used for GPS module Lassen IQ, but for
CMOS camera CAM-VGA100 as well.
Camera CAM-VGA100
GPS module Lassen IQ
2 Supply voltage
The input voltage should be 4.5V – 6V.
Input power should be off before plugging in the GPS module or camera.
3 GPS module Lassen IQ
If you evaluate a Lassen IQ, then please follow the guide line as below,
else jump to chapter number 4 (CMOS camera CAM-VGA100).
Link
pins 1 & 2 of
LK1
to select the NMEA channel.
No link LK2
.
No link
BAT
for the GPS backup battery.
Link
pins
of
LK 4
to enable power to the GPS receiver.
Connect HFL transition cable to Lassen receiver.
Plug in the Lassen GPS receiver.
Link
BAT
for the GPS backup battery.
Connect a straight-through 1 to 1 cable between your PC and the
evaluation board.
Power on the evaluation board.
Using HyperTerminal or similar you will now see the NMEA output from the
GPS receiver.
