Photo 2
Photo 3
Hook strap goes around bar.
Photo 4
Hook in hole on roll bar
Photo 5
Photo 6
2019 JL/JLU Rough Country Mesh Full (Rear) Bimini Top Installation
1. Remove your factory hard top or soft top.
2. On the Rear Mesh, locate the two center buckle straps.
3. Thread the supplied hook straps into the center buckles and hook the straps into the holes located in
Photo 1 & 2
.
Do not tighten yet.
4. On the rear mesh section, locate the two front corner straps. Thread the front facing buckle with the hook strap and
insert the hook into the hole.
See Photo 3
. Do not fully tighten.
5. Take the side facing strap, wrap around the side roll bar and thread it thought he attached buckle.
See Photo 4.
Do
not fully tighten.
6. Locate the rear two straps on the rear mesh.
See Photo 5.
Wrap the side facing strap around the rear of the roll bar
locating it in the “notch” shown in
Photo 6
. Take the rear facing strap and secure it to the side strap under the roll
bar. Thread the strap through the buckle and secure.
7. At this point you will need to tighten all straps previously installed making sure the rear top is centered on the vehi-
cle. Start from the front center straps and work out and back to the rear pulling out any wrinkles.
Photo 1
Photo 2
