Photo 1
Photo 3
Strap goes around vertical bar.
2018 JL/JLU Rough Country Mesh Bimini Top Installation
1. Remove your factory hard top or soft top.
2. Locate the front section of your top and drape the front mesh fabric over the top of your Jeep with the flat straight
edge facing forward.
3. Wrap the long front straps around the Sport Bar, through the gap between the front roll bar and the windshield and
back to the buckle on the strap.
See Photo 1
. Repeat on the other side of the vehicle.
4. Tighten each side strap making sure the top is centered on the vehicle. Adjust as necessary.
5. Locate the two rear corner straps and wrap around the “B” pillar. Thread the straps through the buckle and secure
making sure the top is centered on the vehicle.
See Photo 2 & 3
. Repeat on the other side of the vehicle.
6. Once the rear corner straps are secure and the top is centered, locate the supplied two rear center hook and loop
straps sewn onto the end of the top.
SEE Photo 4
7. Using a T25 Torx bit (found in your on-board Torx tool kit) and driver, remove the screw on the sound bar header
and install the webbing using the same screw
(Photo 5 & 6)
. Thread the Hook and loop strap on the rear of the
mesh top through the rectangle loop and tighten
(Photo 7 & 8)
. Repeat this procedure for the second screw/strap
location. Repeat this on the other side. Secure all straps while making sure the top is centered. When centered
properly, the top will have very few if any wrinkles in it.
Photo 5
Photo 6
Photo 7
Photo 8
Photo 4
Photo 2
Notice Strap location
