18. Once the bushing is out knock the two studs out using a hammer and vise.
See Photo 19.
Replace the two stud with
the supplied 3/8
” x 2.25” bolts, washers, and nuts. Install cab body puck on body bushing and place on truck.
See
Photo 20
.
19. Install the 1.25
” x 3” round body puck onto of rear cab body bushing. Use a 14mm socket and wrench to tighten new
bolt. Lower body onto body bushing and install body bolts but do not tighten at this time. Install a new rear cab bolt
14mm x 140mm.
See Photo 21.
Repeat step for other side.
Make sure the wiring does not get pinch under the
flag bolt on the two front body mounts while installing.
Once all body puck are in tighten all bolts using 19mm
for front body bolts 21mm for middle bolts and 22mm for rear cab bolts.
20. Install emergency brake line bracket using the supplied 1/2
” x 1” bolt, washer, and nut. Use a 19mm socket and
wrench to tighten.
See Photo 22.
Reconnect the emergency brake cable. Take a 1/4 off inch off the original meas-
urement taken adjust the parking brake cable to around 2.25
” from the back of the nut to the end of the threads.
21. Reinstall ground wires and O2 sensor clip back onto frame using 10mm socket. Ground wire on passenger side
body mount be hide tire will need a clip removed to get slack in wire.
PHOTO 19
PHOTO 20
PHOTO 21
PHOTO 22
Summary of Contents for 92130300
Page 15: ......
Page 16: ...Kit Picture Thank you for choosing Rough Country...
