rough country 92130300, Manual

Page: 2 / 16

Tools Needed:
18mm Wrench
15mm Socket
15mm Wrench
17mm Wrench
21mm Wrench
7/32 Allen Wrench
Flat Screwdriver
Hammer
INSTALLATION INSTRUCTIONS
1. Jack up the front of the vehicle and support the vehicle with jack stands, so that the front wheels are off the ground
2. Remove the front tires/wheels., using a 21mm deep well socket
3. Unplug the three wire connectors going to the electric power steering.
See Photo 1.
4. Using a 18mm wrench loosen the upper strut bolts. Do not remove at this time.
5. Place jack stand under the knuckle for support. Remove upper ball joint nut, using a 18mm wrench. Using a hammer
hit the knuckle as shown to allow the ball joint to separate from the knuckle. See Photo 2. Do not allow the knuckle
to pull out far enough that it pulls the shaft out of the differential.
6. Using a 21mm wrench remove the nut from the steering linkage. Using a hammer hit on the front of the knuckle as
shown, where the steering linkage is connected and remove from knuckle. Push linkage forward to make room for
installation. Retain factory hardware.
See Photo 3 .
7. Remove the sway bar nut and bushings using a 15mm wrench, and 15mm socket. Retain factory hardware. See
Photo 4
Photo 1
Photo 2
Photo 3 Photo 4
Kit Contents:
2- Lower Strut Extensions
2– Upper strut spacers
2- 2” Rear Blocks
4– 9/16 U-Bolts
1307 Kit Bag
4-10x1.5x80mm bolts
8-SAE Flat washers
4-10mm nuts
9/16 Kit Bag
8– 9/16 nuts
8– 9/16 washers