1.
Jack up the front of the vehicle. Place jack stand under the frame and lower the vehicle down.
2.
Remove the wheels and tires from the vehicle
3.
Locate the 3 bolts in the front cross brace under the oil pan.
See Photo 1.
4.
Remove the 3 bolts from the front cross brace using an 18mm socket. Then remove the cross brace from the vehi-
cle. Set a side this will not be used.
See Photo 2.
5.
Install 2 of the supplied 1/2
-
13 x 1 1/4 Bolts and 1/2” Flat washer into the top inside of the Drivers side engine mount.
See Photo 3.
6.
Install the drivers side skid plate bracket onto the installed bolts and engine mount. Secure the bracket using the
supplied 1/2” flat washers and nylock nuts.
See Photo 4.
7.
Install 1 of the 1/2
-
13 x 1 1/4 Bolt and 1/2” flat washer into the front hole on the passengers side of the engine
mount.
See Photo 5.
8.
Install the passengers side bracket with the single hole onto the bolt in the engine mount. Secure using the 1/2” flat
washer and the 1/2
-
13 nylock nut.
See Photo 6.
Photo 1
Photo 2
Photo 3
Photo 4
Photo 5
Photo 6
Locate the 3 bolts.
Remove 3 bolts.
Install the drivers side bolts.
Install the drivers side bracket and hardware.
Install the single bolt into the engine mount.
Install the Pass. Side bracket and hardware.
INSTALLATION INSTRUCTONS
Pass.
Front.
Driver
Front.
Driver
Front.
Pass.
Front.
