ROTOSPA OWNERS MANUAL
PG 7
Clean the filter by hosing with fresh water
and, if greasy, soak overnight in a dedicated
filter cleaner available from your dealer, rinse
thoroughly and then reassemble in the reverse
order. The filter will need replacing every 12-18
months and is available form your dealer.
The spa surface can be cleaned by using
a sponge with a mild liquid detergent or
dedicated spa surface cleaner. This can best
be done when the spa is empty and should be
rinsed out well before re-filling. The thermal cover
can be cleaned using a sponge with a mild
non-abrasive liquid detergent in warm water.
You should also clean your spa cover once a
week with a solution of 10mg/l of free chlorine to
disinfect it.
DRAINING
We recommend replacing the water
approximately six times per year (dependent on
usage) to reduce the build up of Total Dissolved
Solids including wastes such as perspiration and
cosmetics. To empty the spa simply use a hose
by holding the end over one of the jets until
water begins to flow out then switch the spa off
and leave to drain with the hose in the foot well.
Alternatively a good quality electric submersible
pump will empty the spa very quickly.
5.
MAINTENANCE
WINTERIZATION
RotoSpa recommends that if you are not using
your spa during the Winter months, simply
reduce the temperature so there are no
issues with freezing pipe. Should you prefer
to turn the power off and drain your spa we
recommend you hire a spa professional.
He should ensure that the spa is completely
drained, unions to the pump and heater are
undone to allow further drainage and the spa
is placed on its side. Any further residual water
to be taken out using professional equipment
as advised.
PLEASE NOTE: Any damage caused by freezing
pipes as a result of incorrect drainage is not
covered by your manufacturer’s warranty.
