ROTOSPA OWNERS MANUAL
PG 3
LOCATION
When selecting a location for your RotoSpa
it should be set on a flat and level surface.
Concrete, paving slabs, tiles and structurally
sound decking are all suitable but it should be
remembered that although RotoSpa products
are relatively lightweight when filled with water
they can weigh well over 1000kg. Siteing the spa
directly onto grass or earth is not recommend as
insects and dust can shorten equipment life. For
the same reason unenclosed below ground use
is also not recommended.
If the spa is sited indoors during use then water
may splash or drip onto the floor both around
and underneath and appropriate care must be
taken to avoid slips and falls. High room humidity
might also require good natural or forced
ventilation to minimise moisture damage to the
building.
SETTING UP
Your RotoSpa is manufactured from a very
tough and hard-wearing material that should
withstand everyday knocks and bumps but we
recommend that care is taken in handling the
spa and protecting the surface from scratching
to preserve its appearance. Once you have sited
your spa the packaging can be removed from
your spa and all of its accessories.
The lockable thermal cover (when supplied) is
rigid and is designed to insulate the spa and
keep water heat in, it is not suitable to be used
for storage of any items placed upon it.
3.
INSTALLATION
CONNECTION
We recommend that you instruct a qualified
electrician to install the spa, it is rated at 13A.
The spa is powered by a 3m electrical cable
extending out of the heater/controller box
through the wall of the spa. Your spa needs to be
sited close enough to the power source to ensure
that the cable can be safely connected to your
power point otherwise a further connection
extension will be required. The spa should be
protected by a RCD; your electrician will be
able to advise you on which type of RCD is most
appropriate for your family’s circumstances.
Once you have connected the power supply
you can refit the plastic panel and the wooden
panel, remembering that the gold coloured D
ring goes behind the centre top screw of the
wooden end panel.
Do not switch on the power before the spa is
filled with water, running the pump whilst dry will
cause catastrophic damage.
