ROTORCOMP NK 100, Operating Manual

Page: 5 / 52

Operating Manual - NK 100
[en] 09/2008 1.1
1 Foreword
1.1 General
This manual contains information and regulations
for the installation and operation of the NK 100
Screw Compressor Compact Module.
1.2 Scope
This documentation is applicable for the screw
compressor of the type NK 100 Compact Module
from the delivery date of 01/2008.
1.3 Change service
This document is not subject to the change ser-
vice.
1.4 Abbreviations
bar (g) Operating pressure
(relative pressure in bar)
Bh Operating hours
DHV Minimum pressure valve
RC ROTORCOMP
SIV Safety valve
Min. Minimum
Max. Maximum
V DC Direct voltage
V AC Alternating voltage
1.5 Manufacturer's information
1.5.1 General information
This operating manual provides information on the
mode of operation, installation, operation and
maintenance of the NK 100. It is must therefore
always be consulted on the operation and mainte-
nance of the NK 100.
Read this operating manual carefully before com-
missioning the NK 100 for the first time in order to
ensure proper handling, operation and mainte-
nance from the outset.
Pay particular attention to all warnings and safety
precautions.
ROTORCOMP screw compressors are carefully
checked and tested prior to shipping. When your
compressor arrives, the delivery scope must be
checked for completeness and damage.
Any missing parts and/or transport damage must
be reported immediately. A damaged compressor
module must not be put into operation under any
circumstances.
Always have the operating manual available for
the operating personnel and make sure that oper-
ation and maintenance are carried out according
to the instructions.
All instructions contained in this operating manual
must be observed in the specified manner and
sequence in order to prevent injuries and damage
to the system.
The screw compressor has been built according to
the latest technology and the recognized safety
rules.
Danger may nevertheless result for the user or
others or for the compressor system during its
use.
Any use other than described in the chapter "Pur-
pose" is considered improper.
ROTORCOMP shall not be liable for any damage
or injuries resulting from such improper use.
We shall not provide any guarantee whatsoever
for malfunctions and damage resulting from failure
to comply with the operating manual.
The manufacturer reserves the right to carry out
further technical developments without prior
notice.
Always specify the model and the complete serial
number from the nameplate in all correspondence.
ROTORCOMP shall assume no liability whatso-
ever for damage or injuries which occur during
handling, operation, maintenance work or repairs
due to a failure to comply with the safety instruc-
tions to proceed with the usual care and caution,
even if this is not expressly mentioned in this oper-
ating manual.