(#15)
. The outer end (the one with the series of holes) bolts to the tongue. Select
the hole which best fits the pulling units drawbar that enables the spreader to run
parallel to the ground. To attach plates
(#21 & #22)
, slide the round stock ends
of these two plates though the tubes which are welded to the ends of the tongue.
Bolt the outer end to the frame (the two plated should be angled upwards with
the stock ends pointed inwards after they are bolted).
B
ABY
-H
OP
O
PERATOR
’
S
M
ANUAL
G
ENERAL
I
NFORMATION
7
R
OTOMEC
Fig. 2