1. make sure there are no obstructions.
2. Run machine under a no-load condition for a short while to assure that
everything is functioning properly.
3. Adjust all settings for the desired quantity distribution and spread pattern.
4. Shift the transmission to a slow speed gear and start forward, increase the
ground speed by shifting upward until the desired speed is obtained. Do not use
in reverse unless absolutely necessary and only after careful observation of the
area behind the spreader.
Before starting to use, never forget that the
operator is responsible
for the following:
1. safe and correct driving of the tractor and spreader.
2. To learn precise, safe operating procedures for both the tractor and the
spreader.
3. To ensure all maintenance and lubrication has been performed on the spreader.
4. To have read and understood all safety aspects for the spreader in the operator's
manual.
5. To have read and understood all safety decals on the spreader.
6. Checking the tractor tires for the proper pressure in accordance with the tractor
operator's manual.
7.
Checking that all shields are on the machine and securely in place.
8. Making sure the proper attire is worn. Avoiding loose fitting clothing which can
become entangled. Wearing sturdy, tough-soled work shoes and protective
equipment for eyes, hands, ears and head. Never operate tractor or implements
in bare feet, sandals or sneakers.
9. Ensuring proper lighting is available, sunlight or good artificial lighting.
3.06 - Operating Techniques
The quantity of material distributed per acre depends on the following factors:
1. spreader ground speed.
2. Unit weight and size of the material to be spread.
3. Spreading width.
4. Position of the lever.
The working speed depends on ground conditions. Only a test run will enable you to
gauge the optimal working speed for your conditions.
Spread adjustment
The Baby Hop's spreading is adjustable in three ways by:
1. regulating the
spread pattern
,
2. regulating the
amount of material to be spread
,
3. regulating the
spreading width
.
To regulate the
spread pattern
slide (to the left or right) the lever
(see #19, fig. 2)
which is located under the hopper and runs through the slot in the disc shielding
(see
#14, fig. 2)
. This moves the spread pattern from 180° at position 0 (in the centre), to
B
ABY
-H
OP
O
PERATOR
’
S
M
ANUAL
O
PERATION
14
R
OTOMEC
