rotho babydesign KOLLER 20306 0001 01, User Manual

Page: 14 / 84

14
2 Safety and Operating Instructions
2.1 Before initial operation
2.1.1 Charge batteries!
• Fully charge the battery prior to first use. The charging process is ended automatically as soon as
the battery is charged. Overcharging is therefore impossible.
• The charging process is complete after approx. 6 hours, which is indicated by a continuously
lit status display, see 2.4.2.
2.1.2 Disinfection
• Before the first use and after every second use, you should follow the disinfection and cleaning
procedure described in 2.9.
• Never put the baby into the disinfecting bath! Keep the whirlpool tub out of the reach of children
during disinfecting!
• Do not use bath additives as these might clog the jet apertures.
2.2 Verifying the Correct Function
• Before every use, check the equipment, power pack and cable for damage.
Do not put the equipment into operation if damaged.
• To prevent danger, do not attempt to repair the equipment and cable yourself;
refer to the service addresses listed on the last page.
• Only use original accessories.
2.3 Safe Positioning
• Choose a safe place and position the equipment on a flat, horizontal and stable surface.
Never put the whirlpool tub on a slanted surface.
• SPA Whirlpool should only be uses with Spa Whirlpool stand 20097 0022.
• Make sure that the castors of the stand are locked.
• Do not place the tub near an electric switchboard and keep a minimum distance
of 24 inches (60 cm) from mains sockets!
• Keep the tub at a safe distance from heat sources!
• To protect children, for example little brothers or sisters, from danger caused by electric
equipment, make sure that the cable is not hanging down and that children cannot reach it.