Rothenberger ROTHERM 2000, Instructions For Use Manual

Page: 14 / 72

12 ENGLISH
 Attach soldering tongs (1) and press pneumatic switch (2) (green control lamp light up).
Control of soldering temperature is better by simultaneously applying the filler wire.
The heating of the fittings depends on the material used and the wall thickness.
 Feed in the solder until the soldering gap is filled and release the switch (2) (green control
lamp off).
 Remove the soldering tongs (1) from the workpiece.
When the soldering tongs is laid aside, attention should be paid to ensure that
objects in the immediate working vicinity are protected from direct contact
with it!
 Remove plug from mains socket (red control lamp off).
4 Care and Maintenance
Repairs should only be carried out by ROTHENBERGER service centres or dealers authorised
by ROTHENBERGER.
Check the electrodes and holders for damage and consumption.
Burned-out flat or stick electrodes should be replaced in good time. Replace the holders if ne-
cessary.
5 Troubleshooting
Symptom Possible Reason
The red “Input Voltage“control LED does
not light up: - no input voltage
- defective mains cable
- the red control LED is defective
- the fuse in the main unit is defective
The green control LED does not light up: - the pneumatic circuit has not been activated
- the air intake to the pneumatic circuit has
been interrupted
- a vacuum has developed in the air in-take
- the overload protection has switched off the
unit temporarily
6 Accessories
Accessory Name ROTHENBERGER Part Number
Flat electrode w.holder,ROTHERM 2000,pair 36711
Flat electrode ROTHERM 2000,pair 36721
Rod electrodes w.holder ROTHERM 2000,pair 36710
Rod electrodes ROTHERM 2000,pair 36720
Steel Case 36715
Fittings solder paste ROSOL 3, 250g 45225
Fitting solder ROSOL 3, 3mm spool,250g 45255
Cleaning fleece ROVLIES,130x60mm,10pcs. 45268
Soft solder flux www.rothenberger.com
Solder www.rothenberger.com
Copper tube internal brushes www.rothenberger.com