GB
15
Allow the appliance to cool down completely, close the gas valve and
disconnect the machine from the mains and gas supply before cleaning,
maintenance or storage.
If the flame extinguishes during use, the gas supply is automatically cut off. Normally, this
only happens in starting the appliance as it is still cold. Repeat the ignition procedure and
keep the gas feed button pressed for a longer time.
CHANGING THE GAS CYLINDER
SAFETY CUT-OUT
If the gas hose bursts, the gas flow is interrupted. The safety device can be reset by
pressing the pressure release button.
HOSE FAILURE SAFETY DEVICE
(SPECIAL ACCESSORIES, INCLUDED IN ROTURBO 35000 & 35000 SA)
- The gas cylinder may be changed only in the open, well away from sources of ignition and
other persons.
- Shut the cylinder valve, switch it off and disconnect it from the mains.
- If the appliance was in use, ensure that the flame has completely extinguished and let the
appliance cool down completely.
- Unscrew the gas regulator and remove it.
- Proceed as described in the section ‘Connecting to a gas cylinder’.
CLEANING
Clean the machine regularly with a dry cloth. Do not use aggressive cleaning agents, solvents
or petroleum spirit. Do not dip or spray the appliance in / with water or other liquids. The
appliance and mainly its openings should be kept free of dust.
MAINTENANCE, STORAGE AND CLEANING
GENERAL MAINTENANCE
- The machine requires very little maintenance.
- Check the seals, hose and mains cable for signs of damage or perishing every 3 months
or if the machine is not used for a longer period of time since these can perish and break
or obtain other damage.
- Do not modify the appliance in any way.
- If the appliance develops a fault have it repaired by a competent person or contact the
manufacturer. See the address at the back of the manual.
Summary of Contents for ROTURBO 12000
Page 115: ...115 ...
