49
User manual
Room air conditioner - TETA X
EN
PART 5. OPERATING INSTRUCTIONS
20. SELF-CLEAN function (Optional)
Only optional for some heating pump inverter appliance. To active this function, turn off the indoor unit at
first, then press
button then you will hear a beep,
will appear on the indoor LED, and will
appear on the remote display .
1. This function helps carry away the accumulated dirt, bacteria, etc from the indoor evaporator.
2. This function will run about 30 minutes, and it will return to the pre-setting mode.
You can press button to cancel this function during the process.
You will hear 2 beeps when it’s finished or cancelled.
NOTE
• It’s normal if there is some noise during this function process, as plastic materials expand with heat and
contract with cold.
• We suggest operating this function at the following ambient conditions to avoid certain safety
protection features.
Indoor unit
Temp < 86°F (30°C)
Outdoor unit
41°F (5°C) < Temp < 86°F (30°C)
• It’s suggested to utilize this function every 3 months.
21. 8°C heating function (Optional)
1. Long press
button over 3 seconds to active this function, and
(
) will appear on the
remote display.
Do it again to deactivate this function.
2. 2. This function will auto start the heating mode when the room temperature is lower than 8°C (46°F),
and it will return to standby if the temperature reaches 9°C (48°F).
3. If the room temperature is higher than 18°C (64°F), the appliance will cancel this function automatically.
22. ANTI-MILDEW function (Optional)
1. In mode COOLING/ DRY, press
button to active this function, and will appear on the
remote display;
2. When turn off the air conditioner from the mode COOLING/ DRY, the indoor unit will continue run
about 15 minutes to dry the indoor unit;
3. Press it again or select other modes to cancel this function.
