Gebrauchsanweisung ○
Mode d’emploi
○
Istruzioni per l’uso
○
Instruction for use
29
•
ASSEMBLY INSTRUCTIONS
o
The fan is packaged with its base and/or other parts unattached. You must attach
them before operating the fan.
o
WARNING
: Never operate without its base and/or other parts attached. Do operate
the fan only in upright position; any other position could create a hazardous situation.
o
No. 4, if available (depending on model), and 7 serve as transport protection and are
removed before installation.
o
Assemble sequence of the base and other parts as follows:
Unpack the fan and remove all the parts from the packaging.
Use the bend bolt and the locking plate (14) provided to attach the stand column
(12) assemblies to the base (13).
Adjust the lift pole to the desired length, then lock it with the locknut for lifting
(11).
Loosen the locknut for switch box (10) and insert the lift pole into the hole located
on the bottom of the switch box (9) in place, then fasten the locknut tightly (10).
Take off the motor shaft cover (7) from the
fan head and unscrew the triangle screw
(5), then take off the fan tie (4) on the back
grill (6) and place the three columns into
the three holes fully. Finally tighten the tri-
angle screw (5) clockwise.
