Rotel RSP-966, Owner'S Manual

Page: 21 / 24

RSP-966
21
TONE/BALANCE Menu
TONE / BALANCE
Bass : +10dB
Treble : +10dB
Balance : L 10
DOWN–selection VOLUME–change
BACK-return MENU-screen off
This menu duplicates the functions of the front panel TREBLE,
BASS, and BALANCE controls and provides a method of changing
them with the remote control. Select a line in the menu using the
UP/DOWN buttons on the remote, then adjust the setting using the
VOL UP/DOWN remote buttons. Return to the MAIN menu by
pressing the BACK button. Cancel the ON-SCREEN DISPLAY by
pressing MENU.
SETUP Menu
SETUP MENU
Front: LARGE
Rear: SMALL
Center: LARGE
Subwoofer: YES
Dynamic Range: OFF
Menu Display: SCREEN
DOWN–selection ENTER–change
BACK-return MENU-screen off
The SETUP menu provides status information and configuration
options for a variety of system parameters. Some of these settings
duplicate the function of front panel controls.
Note 1: See the discussion of speaker configuration under the
SPEAKER MODE button heading in the Front Panel Controls sec-
tion of the manual. Detailed instructions for choosing speaker
types are presented there.
Note 2: Speaker configuration must be performed for each sur-
round mode.
Note 3: Some options described below will not be available in
some surround modes and some system configurations.
FRONT: whether the front speakers are LARGE (full bass re-
sponse) or SMALL (limited bass output)
REAR: whether the rear speakers are LARGE, SMALL, or NONE
CENTER: whether the center speaker is LARGE, SMALL, or NONE
SUBWOOFER: whether there is a subwoofer in the system: YES or
NO
DYNAMIC RANGE: whether the dynamic range compression is
turned OFF (full dynamic range/no compression), MID (moderate
dynamic range/moderate compression), or MIN (minimum dy-
namic range/maximum compression). Only available in Dolby Digi-
tal mode.
MENU DISPLAY: determines whether status information will ap-
pear on screen when volume, input, or other selections are made
– choices are SCREEN (display on) or OFF (display off).
Change any setting by moving the cursor to the desired line using
the UP/DOWN buttons on the remote, change the setting by
pressing the ENTER button to step through the choices. Return to
the MAIN menu by pressing the BACK button. Cancel the ON-
SCREEN DISPLAY by pressing MENU.