30
RR-1061
Clone Function
-q
The CLONE function transfers all programming,
learned commands, labels, and settings from one
RR-1061 to a second RR-1061. To transfer the pro-
gramming, place two RR-1061 remotes with their
IR windows facing each other about 2 to 3 inches
apart, then proceed as follows.
On the remote that will be receiving
the data:
1. Press the SETUP button.
2. Press the UP/DOWN cursor buttons until
CLONE appears in the display. Press the ENT
button to confi rm.
3. Press the UP/DOWN cursor buttons until RE-
CEIVE appears in the display. Press the ENT
button.
On the remote that will be sending the
data:
1. Press the SETUP button (the LCD displays SET-
UP).
2. Press the UP/DOWN cursor buttons until
CLONE appears in the display. Press the ENT
button to confi rm.
3. Press the UP/DOWN cursor buttons until
SEND appears in the display. Press the ENT
button.
The data transfer begins. The sending remote dis-
plays SENDING DATA. The receiving remote dis-
plays RECEIVING DATA. At the completion of the
data transfer (which may take 4 or 5 minutes), one
of the following confi rmation messages appears
in the display of the receiving RR-1061:
• If the data transfer is successful, the SEND
OK prompt appears on the sending remote
and RECEIVE OK appears on the receiving
remote.
• If the data transfer is not successful, ERROR ap-
pears in the LCD on the receiving remote. and
the unit reverts to normal operating mode.
RR-1061 - En-Fr - a.indd Spread 30 of 32 - Pages(30, 35)
