BRP-Rotax
INSTALLATION MANUAL
INSTALLATION NOTES
General
The representation of components in this chapter which are not scope of the delivery is
only symbolic. The design shown in this chapter does not represent a specified execution
but should support the understanding of the system.
The final design, the selection and specification of parts according to the respective appli-
cable regulations, the consideration of the system limitations and interface description as
well as the comprehension of the operating limits in every operational state is in the re-
sponsibility of the aircraft manufacturer.
The aircraft manufacturer has to make sure that the operating limits given in the Operators
Manual can be supervised by the pilot. The execution of the installation must allow the op-
eration of the engine according to the Operators Manual.
INSTALLATION OVERVIEW
Figure 10.5: Harness Interface Connector A-Schematic
Part
Function
1
Harness Interface Connector A
2
Warning Lamp A (-H1)
3
Warning Lamp A (LED) (-H1 V2)
4
Resistor 1.5 kΩ (-F6)
5
Resistor 1 kΩ (-F7)
Page 8
December 01 2017
Effectivity: 915 i A Series
Edition 0/Rev. 0
Summary of Contents for 915 iS 3 A
Page 165: ......
