SlushPlow Install
Congratulations on purchasing a Slush Plow. This attachment for your new snow blower will push snow
and slush. The attachment is easy to install, just follow the instructions that have been provided for you.
Please make sure the size of the plow is larger than the blower housing. If the plow is smaller than the
blower housing, please return and purchase the correct size plow. Please be aware the snow blower must
have a transmission for this attachment to work. The transmission must be in good condition for the
attachment to work. If the transmission slips, take it to a repair shop for a simple fix or adjustment.
WARNING
engine must be turned off when installing and uninstalling plow.
( Note that some models have holes pre-drilled from the manufacture. Toro, MTD, Cub Cadet, Sears, Troy
Bilt, Simplicity, Snapper (do not have pre-drilled holes). Ariens models only have these holes. If the holes
line up with the brackets you can accommodate those models or you must drill new holes and follow the
instructions. )
Steps:
Measure the height of the blower housing. If less than 20" please contact us, the
company will switch out the brackets for the smaller ones.
1) Assemble shown on picture.
2) Place plow in front of snow blower make sure
it's place equally from both sides. Take template
that has been provided for you, place it at the edge
& middle of the housing and mark your holes.
3) Cut the red dotted line off the template. Then
drill a 5/16 hole.
4) Mount your brackets underneath the blower
housing with your bolt and large rubbers.
Rubber mounts have two different face, oval
and flat. Oval sits on top of the bracket. The
flat side sits on the bottom of the snow blower.
Rotate the rubber on the top of bracket until
the correct position is achieved. Look at
picture.
5) Place knobs on top of the housing and tighten
the brackets to the correct angle of the plow. Adjust
the height of the squeegee so it hovers flat from the
ground.
( Note plow should be angled 90
degrees from the ground )
.
