10 of
10
Figure 6 -Shoulder seal
26R-2
26R-5
26R-10
26R-17
26R-31
26R-62
26R-124
L
Dimension
.024-.029
.037-.042
.037-.042
.058-.063
.058-.063
.081-.087
.081-.087
1. Place half of the shoulder seal shim set in the bottom of the seal groove.
2. Place the shoulder seal cushion into the groove. (Make sure that the cushion is seated in the
bottom of the groove.
3. Install the shoulder seal wedge with the flat side against the cushion as pictured above.
4. Place the shoulder seal cap against the wedge so the 45-degree angles match as pictured above.
5. Check the amount of cap protrusion into the body, (L dimension) using a straight edge and shim
stock.
6. Adjust, if necessary, the amount of shim stock in the shoulder seal groove until the L dimension is
within the tolerance listed in the chart above.
7. Proceed with the installation of the shoe.
