Issue 4
Original version
March 2010
5
[2] SAFETY PROCEDURES
READ BEFORE USING THE MACHINE
Always secure the machine with the safety strap RD4329 before starting to operate
-‐ for the user's
protection in case the magnetic base breaks loose whilst in use. Failure to do so may result in personal injury.
Always wear approved eye and ear protection when the equipment is in operation.
Failure to do so may
result in personal injury.
Disconnect from hydraulic supply source when changing cutters or working on the machine. Ensure that the
hydraulic supply is connected after positioning the machine.
Never pick the machine up by the cutter as this is sharp and may injure you.
Always ensure cutter retaining screws are secure –
they can sometimes vibrate loose during use.
Regularly clear the work area and machine of swarf and dirt, paying particular attention to the underside of
the magnet base.
With a gloved hand, and after switching off, remove any swarf, which might have gathered around the cutter
and arbor before proceeding with the next hole.
Before operating the machine, remove tie, rings, watches and any loose adornments, which might entangle
with the rotating machinery. Ensure long hair is tied back.
Ensure that the magnet is fully activated before attempting to cut a hole.
Should the cutter become ‘fast’ in the work piece, switch off the motor immediately to prevent personal
injury. Disconnect from the pneumatic supply and turn arbor to and fro.
Do not attempt to free the cutter by
switching the motor on and off.
If the machine is accidentally dropped, always thoroughly examine the machine for signs of damage and check
that it functions correctly before trying to drill a hole.
Regularly inspect the machine and check that all nuts and screws are tight.
Cutting tools may shatter
always
extended the guard over the cutter during the drilling operation. Failure to
do so may result in personal injury. When moving the machine ensure the guard is over the cutter failure to do
so may cause injury.
On completion of the cut, a slug will be ejected. DO NOT operate the machine if the ejected slug may cause
injury.
Ensure an adequate supply of coolant is supplied to the cutter during the cutting cycle.
Manual handling
When moving the machine always ensure that you use the carry handle on the machine failure to do so may
cause damage to the machine.
Caution this machine is heavy and may require help manoeuvring especially when working
overhead.
