Rossofuoco RUBINO, User And Maintenance Manual

Page: 15 / 24

To clean it is recommended to use cleaning products for glass and cloth. Removing every time
any pellet residuals inside the burner to avoid that the pyrolysis doesn’t occur correctly in the next
ignition.
Every 2/3 usage of the Heater, it is recommended a lubrication of the burner’ sliding guides, to
avoid the malfunction of the system.
Glass tube cleaning (mod. RUBINO):
1. it makes sure that there isn’t flame and the Heater is cold and off;
2. open the heat diffuser door;
3. lift upwards the glass to bring it out from the base and extract it from the grate;
4. spray inside with cleaning products;
5. in the tube inserts a big quantity of kitchen towel or a dry cloth;
6. help yourself with a tube or a stick with a smaller diameter than the tube’s one and push the
kitchen towel or the dry cloth until bring them out on the other side of the tube;
7. in the event that the tube would have droplets of humidity or their residues, having been
outdoor, eliminate them with the use of common glass cleaning product. Spray it on the tube
and dry it carefully; for the inner part of the tube you follow the instructions on the point 4.
8. after tube cleaning, you have to reposition the glass tube inclining and reinserting it before
with an upward movement and then with a downward one until you reinsert it correctly in its
place on the base of the Heater;
9. close again the heat diffuser door.
Glasses cleaning (mod. DIAMANTE):
10. it makes sure that there isn’t flame and the Heater is cold and off;
11. spray the glasses with cleaning products;
12. clean using kitchen towel or a dry cloth;
13. in the event that the tube would have droplets of humidity or their residues, having been
outdoor, eliminate them with the use of common glass cleaning product. Spray the glasses
and dry them carefully;
14. nel caso in cui i vetri, essendostati all’esterno presentassero goccioline di umidità o loro
residui procedere alla loro eliminazione spruzzandoli con comuni prodotti per la pulizia dei
vetri, pulendoli ed asciugandoli con un panno agendo con la cura l’attenzione dovute;
15. after the cleaning pulizia effettuata check the correct positioning of the glasses.
To avoid that the dust of the combustion will form a crust and it makes the tube or the glasses
impossible to be clean, you have to perform the cleaning after every combustion or at the latest
two combustions.
Structure cleaning:
16. cleaning also the varnished parts with a soft cloth, water and mild soap;
17. cleaning carefully the ash of the Heater as previously described in these instructions.
FOR ANY OPERATIONS OF CLEANING IT IS RECCOMENDED TO NOT USE ABRASIVE OR CORROSIVE PRODUCTS.
CLEANING AND MAINTENANCE
page 11
Always with the previous precautions. For the cleaning operations and products to use make
reference to the indications in the following specific chapter.