Rossofuoco RUBINO, User And Maintenance Manual

Page: 14 / 24

page 10
Throughout the combustion do not open the door of the base.
It is recommended to make the heater works for the entire duration of the pellet combustion.
The suggested pellet quantity is roughly calculated because the Heater filled with a few quantity of
pellet produces an higher flame because there is more air inside the burner, but the duration will
be shorter. On the contrary if the Heater is filled with a big quantity of pellet the duration will be
longer but the flame will be lower because of the minor quantity of air inside the burner.
When the flame finishes the Heater keep on heating for at least 2 hours depending on the initial
quantity of pellet which continues to heat also there isn’t open flame.
The Heater can be filled again opening the drawer under the burner, according to the instructions
at the following points from 7 to 12 ( unload and cleaning operations) and then following the
instructions at the previous points from 3 to 6 ( loading and firing up ) for refuelling the burner with
additional pellet.
Once the Heater is on, it will work with a pyrolysis process (fig. at page 08) which consists in the
top-down anaerobic combustion of the pellet. This process will transform the combusted pellet in
a completely natural compound, that will be easy to dispose of. Anyway, pay attention to the rules
in force in your country about the separate collection.
Unloading:
7. open the door of the base and extract the burner;
8. Wearing the appropriated fireproof mitts, remove the top of the ash drawer;
9. Keep wearing the fireproof mitts, you have to operate the opening of the part underneath
the burner so you can drop the combustion residues inside the ash drawer;
10. Clean the inside of the breazier, using the poker if necessary, removing any residual pellets
even if still burning.;
11. please check that the edges and the lower door are clean so to have a perfect closing; then
close it;
12. close the drawer with its cover.
WARNING: THE ASH DRAWER HAS TO BE EMPTIED ONLY WHEN THE COMBUSTION RESIDUES INSIDE WILL BE
COMPLETELY COLD AND OFF. FOR THE DISPOSAL YOU HAVE TO RESPECT THE RULES IN FORCE IN YOUR COUNTRY
ABOUT THE SEPARATE COLLECTION
Reload:
When you executed the operations until the previous point 12, the Heater is ready to be used
again. You have only to repeat the load procedure restarted from the point 3 of the “LOADING AND
FIRING UP” instructions.
It is reiterated that:
• When the Heater is hot, its functioning and status has to be constantly controlled;
• The operations on the Heater has to be done always with the standard issue protections and
taking the necessary precautions to avoid burns.
• The temperature and the duration of the flame indicated on the previous schedule of this
manual and on the Heater’s brochure are purely indicative and they are directly evaluated
and regulated according to common sense and specific conditions of the Heater’s user and
what kind of pellet used.
• After every ignitions it is recommended to clean well the Heater, to empty the ash drawer
with the opening under the burner using the attention and care recommended previously.
The cleaning of the burner can be done both leaving inside the base the burner, opening
the top of the ash drawer, and extracting the burner and the ash drawer from the Heater.