Installation
14
AYC-F/Gx4 Series Installation and Programming Manual
6.
Insert the unit’s cable wire into the cable hole and wire the unit
as described in Section
7.
Screw the unit to its mounting location or US gang box.
8.
Carefully re-attach the front cover of the unit.
9.
Secure the front cover by using the supplied security Torx screw.
A Torx security screw tool is provided to tighten the security Torx
screw.
3.2
Wiring
The unit is supplied with a 6-conductor 150-cm (60-in.) pigtail with
exposed wires coated with solder.
3.2.1
Wiring the Unit as a Reader
If you connect the unit to a standard access control unit, it
automatically functions as a reader.
To connect the unit as a reader (to a controller):
1.
Select the appropriate connections according to Table 1.
Table 1: Wiring the Reader to the Controller
Wire Color Function
Black/Shield
Ground (+)
Red
Vin (-)
Green
Data 0/Data (D0)
White
Data 1/Clock (D1)
Brown
LED control
Purple
Tamper
2.
Prepare the controller cable by cutting the cable jacket back 3.2
cm (1¼”) and strip the wire 1.3 cm (½”).
3.
Splice the reader’s pigtail wires to the corresponding controller
wires and cover each joint with insulating tape.
4.
If the tamper output is being utilized, connect the purple wire to
the correct input on the controller.
