Installation
AY-M26 Installation and Configuration Manual
11
3.3
Installing the AY-M26 Reader
1.
Determine an approximate location for the reader.
2.
Peel off the back of the self-adhesive mounting label template
and place it at the required mounting location.
3.
Using the template as a guide, drill two holes (sizes indicated on
the template) used for mounting the reader onto the surface.
4.
Insert a suitable wall plug into each hole.
5.
Drill a 10-mm (
7
/
16
”) hole for the cable. If mounting on metal,
place a grommet or electrical tape around the edge of the hole.
6.
Route the interface cable from the reader to the controller. A
linear type power supply is recommended.
7.
Remove the reader's snap-off front cover to reveal the two screw
holes, see figure below.
Figure 1: Removing the Top Cover
8.
Align the two holes of the reader with those drilled in the wall
and firmly attach the reader to the wall with two screws, whose
size is indicated on the template.
9.
Relocate the front cover onto the reader.
The reader can also be mounted using strong epoxy glue. After
application, the reader should be firmly held in place until the
glue dries.
