3–4 • User Controls
TEA-8207 User Manual (Iss. 06)
Factory Default Values
Any channel can be set back to factory settings, where the data rate is set to
HD
and the alarm is
enabled on loss of input.
Use the following procedure to reset a channel to factory default values:
1.
Press and hold the
Bootload
button on the card.
2.
Press the Rate Selection button for the selected channel. The
Signal Status LED
flashes
green and red for approximately 2 seconds to confirm the reset values.
This completes the procedure for resetting a channel to factory default values.
PWR
Red
When lit red or flashing red, this LED indicates the card is not
operational. Re-seat card in frame, check the rear module type
and connections, or call Ross Video Technical Support.
Off
When off, this LED indicates there is no power to the card.
OK/ERROR
Green
When lit, this LED indicates that a valid SDI input signal is
present.
Red
When red, this LED indicates that the SDI input signal is missing
or invalid.
HD
When lit, this LED indicates that the reclocker is set to a fixed
rate of 1.5Gbps, or is configured in Auto mode and is locked to a
1.5Gbps signal.
SD
When lit, this LED indicates that the reclocker is set to a fixed
rate of 270Mbps, or is configured in Auto mode and is locked to
a 270Mbps signal.
Table 3.1 LEDs on the TEA-8207
LED
Color
Display and Description
