TEA-8207 User Manual (Iss. 06)
Installation • 2–3
Installing the TEA-8207
The TEA-8207 are compatible with the DFR-8300 series frames. The procedure for installing the
rear module in your openGear frame is the same regardless of the frame, module, or card used.
Rear Modules for the TEA-8207
The rear module for the TEA-8207 depends on the openGear frame you are installing the card
into.
•
DFR-8310 series frames
— When installing the TEA-8207 in a DFR-8310 series frame,
the
8310AR-030
Rear Module (R1-8207) is required. The TEA-8207 is also compatible
with the DFR-8310-BNC frames.
•
DFR-8321 series frames
— When installing the TEA-8207 in a DFR-8321 series frame,
the
8320AR-030
Full Rear Module (R2-8207) is required.
Installing a Rear Module
If you are installing the TEA-8207 in a DFR-8310-C-BNC or DFR-8310-BNC frame, or if the
rear module is already installed, skip this section.
Use the following procedure to install the rear module in a DFR-8300 series frame:
1.
Refer to the
DFR-8300 Series User Manual
to ensure that the frame is properly
installed according to instructions.
2.
Locate the card frame slot on the rear of the frame.
3.
Remove the Blank Plate from the rear of the slot you have chosen for card installation.
4.
As shown in
Figure 2.1
, seat the bottom of the rear module in the seating slot at the base
of the frame’s back plane.
Figure 2.1
Rear Module Installation in a DFR-8310 Series Frame (TEA-8207 not shown)
