Ross Synergy 100 MD, Operator'S Manual

Page: 91 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Transitions • 5–11
4. Press
CUT
. The inputs selected on the PGM and PST buses instantly exchange and the
buses flip-flop. The figure below illustrates the MLE and monitor setup after the cut.
Sample Setup – After a Cut
5. Press
CUT
again to repeat the process and restore the original background.
This completes the procedure for performing a cut.
Performing Dissolves
In a “background dissolve” transition, the PGM bus video and PST bus video signals are gradually
mixed together, until the PST bus video completely replaces the PGM bus video. Refer to the section
“ Using Wipes ” on page 6–6 for complete instructions on performing wipe transitions.
Although we have used BKGD transitions between the PGM and PST buses as examples in the
following procedure, remember that all types of transitions operate in the same manner, regardless of
the
Next Transition buttons selected.
Use the following procedure to perform a dissolve:
1. Select an input on the PGM bus.
2. Select a different input on the PST bus.
3. In the Next Transition Section , select BKGD as the next transition. The figure below
illustrates a sample setup and the associated monitor outputs — before the dissolve.
Sample Setup – Before the Dissolve
KEY1
KEY2
DSK
PGM
PST
BLACK
BLACK
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
BLACK
Preview Monitor
(CAM 2)
Program Monitor
(VTR 1)
KEY1
KEY2
DSK
PGM
PST
BLACK
BLACK
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
BLACK
Preview Monitor
(VTR 1)
Program Monitor
(CAM 2)