Ross Synergy 100 MD, Operator'S Manual

Page: 100 / 402

6–6 • Pattern and Effects Control Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Using Wipes
In a “background wipe” transition, the PGM bus video is gradually replaced with the PST bus video
according to a wipe pattern pre-selected in the Effects Control Group .
Use the following procedure to perform a wipe:
1. Select an input on the PGM bus.
2. Select a different input on the PST bus.
3. In the Transition Control Group, select BKGD as the next transition. The following
figure illustrates a sample setup and the associated monitor outputs — before the wipe.
MLE and Monitor Setup – Before the Wipe
4. Press WIPE . This action causes the lamp on the WIPE button to illuminate yellow and
automatically assigns the Effects Control Groups to the transition.
5. Press the pattern button for the desired wipe.
6. Choose the direction for the wipe. Select between normal, reverse, or flip-flop by
pressing or double-pressing the REV/LEARN button.
7. Turn the BORDER knob fully clockwise, then fully counterclockwise. For this first
exercise, this ensures that there is no border .
8. To perform a manual transition, move the Fader from limit to limit. To perform an auto
transition, press the AUTO TRANS button. During the transition, the PST bus video
signal gradually replaces the PGM signal using the selected wipe, as the following
figure illustrates.
MLE and Monitor Setup – Performing a Transition
At the end of the transition, the PST video completely replaces the PGM video and the
buses flip-flop.
KEY1
KEY2
DSK
PGM
PST
BLACK
BLACK
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
BLACK
Preview Monitor
(VTR 1)
Program Monitor
(CAM 2)
KEY1
KEY2
DSK
PGM
PST
BLACK
BLACK
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
BLACK
Preview Monitor
(VTR 1)
Program Monitor
(VTR 1 and CAM 1)