Ross SRG-4400, User Manual

Page: 35 / 193

SRG-4400 User Manual (Iss. 06) Functional Check Procedures • 3–5
Initial Configuration
The SRG-4400 should arrive configured to a “factory default” condition, i.e. all video outputs
will have a pattern selected that is relevant to the format of the output, all of the audio channels
will be configured for “1kHz Tone and Silence”, etc.
Additionally, any pre-ordered options (i.e. GPS or NTP) will have been enabled. This can be
confirmed by viewing the Option Enable page in the menu; enabled options will have valid
Option Keys entered for them. Refer to the section “
System Setup Menus ” on page 5-39 for
more details.
The following procedures will systematically progress through all of the outputs available from
the SRG-4400. The range of menu entries available for each procedure may relate to whether
associated options have been enabled.
In all but the first of the procedures that follow, some intermediate instructions relating to cursor
movements and control button presses may have been omitted for clarity.
Also, menu screens almost always contain more lines then can be displayed on the LCD or the
OSD - be sure to scroll up/down to find the menu entry you require.
Note
— [Confirm] indicates that you should press the Rotary Control, and [Back] indicates
that you should press the blue push-button.