Ross SRG-4400, User Manual

Page: 93 / 193

SRG-4400 User Manual (Iss. 06) Menu System • 5–39
System Setup Menus
The System Setup menu appears below:
Figure 5.17 System Setup Menu Example
When the GPS option is not installed/enabled, the “GPS Report” line appears as:
“-GPS........Option not enabled”
The System Setup menu provides a gateway to the less frequently used options in the SRG-4400.
These options include:
• Extended information in the form of reports
• Extended configuration options
• Access to factory settings that the user should never have to access or adjust, but may
contain useful information to communicate to the factory during a service event.
Temperature Reports
The Temperature Report appears below (general form).
Figure 5.18 Temperature Reports Menu Example
The Temperature Report provides information on the temperature sensors within the SRG-4400.
A typical example might look like:
+3v3 Regulator 42 45 41
Depending on the exact configuration and options in the SRG-4400, only those sensors that are
detected will be displayed. If a sensor is installed but has failed, the description in the relevant
line appears as:
Fixed PSU -Sensor absent
Note
— Reports menus contain information only; there are no editable fields in these menus.
— Configuration —> Menu Enter
— Network
—>
Menu Enter
— GPS Report —> Menu Enter
— System Report —> Menu Enter
— Event Report —> Menu Enter
— Temp Report Menu Enter —>
— LipSync Report —> Menu Enter
— Calibration —> Menu Enter
— Option Enable —> Menu Enter
N+1 Left PSU
+3v3 Regulatory
N+1 Interface 45 45 45
+1v2 Regulator 45 45 45
45 45 45
45 45 45
L PSU turned on
nnnnn times
N+1 Right PSU 45 45 45
R PSU on for hhhhh.ddd hours
R PSU turned on nnnnn times
L PSU on for hhhhh.ddd hours