Note:
During normal operation the pressure washer
pump motor will only start when the trigger is
squeezed and will stop when the trigger is released.
HIGH PRESSURE LANCE SAFETY LOCK
In order to prevent accidental operation of the high
pressure lance, the gun is fitted with a safety lock. To
disable the safety lock, push the safety lock button to
the right,
Fig 7.
To enable the safety lock, release the
trigger and push the button to the left.
Check that the On/Off switch is in the OFF (0) position,
Fig 3.
The water inlet is fitted with a particle filter and if
not fitted must be fitted prior to use.
Fig 4
. This
filter must not be removed except for examination
and cleaning. The inlet water filter should ideally be
checked and if required cleaned before each use.
Screw the high pressure hose to the high pressure
water outlet,
Fig 6
. Do not use water which exceeds
60°C.
PRIME THE PRESSURE WASHER
Turn on the water supply and squeeze the gun trigger
until the water flows in a steady stream through the
lance.
Screw the male, quick connector onto the pressure
washer water supply inlet,
Fig 5.
Attach a hose pipe
with a female quick release connector (not supplied) to
the male quick connector on the power washer.
OPERATION
CAUTION!
Before connecting to the mains power supply please
ensure that the ON / OFF switch is in the OFF posi-
tion and the water supply is connected and is turned
on. Running the pressure washer without any water
supplied to it will damage the pump and VOID your
warranty.
SWITCHING ON
Connect the pressure washer mains lead to the mains
electricity supply via a residual current device (RCD)
(not supplied). Start the power washer by turning the
On/Off switch to the ON (I) position,
Fig 7.
FIg 6