Ross openGear GPI-100, User Manual, Page: 26 / 42

3–2 • User Controls GPI-100 User Manual (Iss. 06)
Card Overview
This section provides a general overview of the GPI-100 card components.
Figure 3.1 GPI-100 — Components
1. Bypass Switch (SW1)
If the GPI-100 is installed in the MDL-R20 rear module, this two-position push-button can be
used to control the relay.
• When the push-button is in the IN position, the GPI-100 is in the video signal path.
• Pressing it once moves the switch to the OUT position and bypasses the GPI-100.
• Pressing it again restores the GPI-100 to its active state.
2. Menu Switch (SW2)
This switch is not implemented.
3. Reset Switch (SW3)
This button is used for rebooting the card. Refer to the section “ Reset Button ” on page 6-2 for
details.
For More Information on...
• the LEDs available on the card-edge, refer to the section “ Control and Monitoring
Features ” on page 3-3.
1) Bypass Switch (SW1) 2) Menu Switch (SW2) 3) Reset Switch (SW3)
1
2
3