Ross openGear GPI-100, User Manual, Page: 27 / 42

GPI-100 User Manual (Iss. 06) User Controls • 3–3
Control and Monitoring Features
This section provides information on the card-edge LEDs for the GPI-100. Refer to Figure 3.2
for the location of the LEDs.
Figure 3.2 GPI-100 Card-edge Controls
Status and Selection LEDs on the GPI-100
The front-edge of the GPI-100 has LED indicators for communication activity. Basic LED
displays and descriptions are provided in
Table 3.1 .
Table 3.1 LEDs on the GPI-100
LED Color Display and Description
POWER
(DS1)
Green
When lit green, this LED indicates that the card is running with
a valid input.
Flashing Green
When flashing green, this LED indicates that the bootloader is
waiting for a software upload.
Yellow
When lit yellow, this LED indicates there is a warning for a
signal or a configuration error is occurring.
Red
When lit red, this LED indicates that the card is not operational.
This will occur if, for example, there is not video input.
Off When off, this LED indicates that there is no power.
BYPASS
(DS2)
Red
When lit red, this LED indicates the GPI-100’s video is
bypassed.
Off
When off, this LED indicates that the GPI-100 is in the video
path and is capable of inserting data.
POWER LED (DS1)
BYPASS LED (DS2)
Bypass Switch (SW1)
PGM VIDEO IN LED (DS3)
PGM VIDEO OUT LED (DS4)
DS5 LED
DS6 LED
DS7 LED
DS8 LED
VIDEO ERROR LED (DS9)
UNKNOWN REAR MODULE LED (DS10)
DS11 LED
DS12 LED
Reset Button (SW3)
Menu Switch (SW2)